Note
Access to this page requires authorization. You can try signing in or .
Access to this page requires authorization. You can try .
Remove-AutoSensitivityLabelPolicy
- Module:
- Exchange PowerShell
This cmdlet is available only in Security & Compliance PowerShell. For more information, see Security & Compliance PowerShell.
Use the Remove-AutoSensitivityLabelPolicy cmdlet to remove auto-labeling policies from your organization.
For information about the parameter sets in the Syntax section below, see Exchange cmdlet syntax.
Syntax
Default (Default)
Remove-AutoSensitivityLabelPolicy
[-Identity] <PolicyIdParameter>
[-Confirm]
[-WhatIf]
[<CommonParameters>]
Description
To use this cmdlet in Security & Compliance PowerShell, you need to be assigned permissions. For more information, see Permissions in the Microsoft Purview compliance portal.
Examples
Example 1
Remove-AutoSensitivityLabelPolicy -Identity "Marketing Group"
This example removes the policy named Marketing Group.
Parameters
-Confirm
Applicable: Security & Compliance
The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on whether the cmdlet requires confirmation before proceeding.
- Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax:
-Confirm:$false. - Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you to acknowledge the command before proceeding.
Parameter properties
| Type: | SwitchParameter |
| Default value: | None |
| Supports wildcards: | False |
| DontShow: | False |
| Aliases: | cf |
Parameter sets
-Identity
Applicable: Security & Compliance
The Identity parameter specifies the auto-labeling policy that you want to remove. You can use any value that uniquely identifies the policy. For example:
- Name
- Distinguished name (DN)
- GUID
Parameter properties
| Type: | PolicyIdParameter |
| Default value: | None |
| Supports wildcards: | False |
| DontShow: | False |
Parameter sets
-WhatIf
Applicable: Security & Compliance
The WhatIf switch doesn't work in Security & Compliance PowerShell.
Parameter properties
| Type: | SwitchParameter |
| Default value: | None |
| Supports wildcards: | False |
| DontShow: | False |
| Aliases: | wi |
Parameter sets
CommonParameters
This cmdlet supports the common parameters: -Debug, -ErrorAction, -ErrorVariable, -InformationAction, -InformationVariable, -OutBuffer, -OutVariable, -PipelineVariable, -ProgressAction, -Verbose, -WarningAction, and -WarningVariable. For more information, see about_CommonParameters.
Feedback
Was this page helpful?